Circuit Library
Circuits ready to build, shared by people using Circuit Canvas. Each one comes with a parts list, a schematic and a picture showing how to connect it all on a breadboard, perfboard or stripboard. Want to change something? Make your own copy in one click.
Featured
-
555 Timer: Running LEDs (Knight Rider)
This circuit creates a light that "runs" back and forth using a 555 timer and a decade counter. It's effect is similar to the light bar on the car from the…
-
Laser-Triggered Sound Player
This project creates a laser trip-wire that when triggered plays a sound. The sound is stored on an SD card in MP3 format, so it can be any sound you like -…
-
Step-Triggered Sound Player
This project creates a step-activated trigger that plays a sound for example when someone steps on your door mat. The sound is stored on an SD card in MP3…
-
Mini Monster Box
This is my mini monster box: Knock on the box, and a grumpy little monster pops out to see who's there. A microphone hears the knock, a one-transistor…
-
Automatic Garden Lights
A circuit that turns on your garden lights at night. This circuit is connected between the power source of my garden lights and the lights. When the night…
-
Schnaps Song Player
This is a simple circuit to play a song with ATtiny85. It plays the hardcoded song one time at start-up, then stops. To play the song again, you need to press…
Newest circuits
-
10-LED Running Lights
Ten LEDs light up one after another, like a running light. Turn the knob to change the speed, from a slow walk to a fast race. Built with parts from the…
-
Light Theremin
Play music by waving your hand! Move your hand over the light sensor and the pitch changes: more light gives a higher tone, less light gives a lower one.…
-
Arduino Traffic Lights
A simple traffic light project that simulates the behaviour of European traffic lights: first red, then red + yellow, then green, then yellow. This repeats…
-
LDR Dark Detector (LED Turns On in the Dark)
A dark detector with an LDR (photoresistor) and a BC557 PNP transistor. When it gets dark, the LDR's resistance rises, the transistor turns on and the LED…
-
LDR Light Detector (LED Turns On in Light)
A simple light detector with an LDR (photoresistor) and a BC547 transistor. When light hits the LDR, its resistance drops, the transistor turns on and the LED…
-
Blinking an LED
This is a simple LED blinker circuit. Once connected, the LED will flash on and off.
-
Fading LED (Capacitor Demo)
Press the button and the LED turns on. Let go, and instead of switching off, it slowly fades out over a few seconds.
-
Pushbutton Flashlight
Press the button and the LED lights up. Let go, and it turns off. That's a flashlight! The resistor limits the current so the LED doesn't burn out. Built with…
-
Automatic Night Light
A simple night light that turns on an LED automatically when it gets dark. No microcontroller needed: just a photoresistor, a transistor and two resistors on…
-
Variation on Blinking LEDs
This circuit uses no MCU and blinks each of the lights using a capacitor and transistor. I found the original circuit on www.circuitdiagram.com . I used…
-
Step-Triggered Sound Player
This project creates a step-activated trigger that plays a sound for example when someone steps on your door mat. The sound is stored on an SD card in MP3…
-
Laser-Triggered Sound Player
This project creates a laser trip-wire that when triggered plays a sound. The sound is stored on an SD card in MP3 format, so it can be any sound you like -…
-
Candle-Flicker LED Strip
This project uses a flickering LED (one of those that you only need to connect to power and it will flicker light a flame). By using a resistor and an…
-
RT9080-33
Low-quiescent 3.3 V supply for running ESP32 and other 3.3 V logic from a single 18650 Li-ion cell. Built around the Richtek RT9080-33 fixed 3.3 V LDO: 600 mA…
-
Nanobrick
This project exhibits the full functionality of the Arduino Nano 33 Ble sense rev 2. Latest sketch and 3D files: https://github.com/Dominic-7-Sieben/Nanobrick…
-
Mini Monster Box
This is my mini monster box: Knock on the box, and a grumpy little monster pops out to see who's there. A microphone hears the knock, a one-transistor…
-
MFC Polarisation Sweep Datalogger
A polarisation sweep datalogger for Microbial Fuel Cell characterisation. The circuit includes a Heltec WiFi LoRa 32 v3, an ADS1115 module, an 8 Relay Module,…
-
Scoreboard Display
A simple project that counts the number of times you've pressed the button. Can be used as a scoreboard display for a game. Or to keep tracks of things like…
-
555 Timer: Blink LED
Here's how to build a simple LED blinker using a 555 timer. The 555 timer is configured as an astable multivibrator, which means the output will turn on and…
-
555 Machine Gun
This "machine gun" circuit generates a sound that mimics the sound of a toy machine gun. It is based around a 555 timer IC in a feedback loop. Check out this…
-
555 Timer: Running LEDs (Knight Rider)
This circuit creates a light that "runs" back and forth using a 555 timer and a decade counter. It's effect is similar to the light bar on the car from the…
-
IR Remote Switch v2
This project shows you how to create a simple remote-controlled on-off switch that will work with most IR remote controls. And you only need four components…
-
Arduino Memory Game
This is a simple Memory Game game built with Arduino. The point of the game is to repeat the sequence of colors that the Arduino comes up with. The sequence…
-
Arduino Melody Player
This is a simple project where you connect a buzzer to your Arduino to play a melody. You'll use Arduino's tone() function to play different tones and combine…