10-LED Running Lights

This circuit is live in Circuit Canvas. Open it to explore every part and wire, or make your own copy to change values, swap parts and build your own version. Free, right in your browser.

Ten LEDs light up one after another, like a running light. Turn the knob to change the speed, from a slow walk to a fast race.

Built with parts from the Starter Kit.

10-LED Running Lights Schematic

The 555 timer (U1) sends out a steady stream of pulses. R1, R2, the potentiometer (RV1) and the capacitor (C1) set how fast they come: turn the knob, and the speed goes from about one step per second to about ten.

The CD4017 counter (U2) moves its output one step forward on every pulse, from Q0 to Q9, and then starts over. Only one output is on at a time, so all ten LEDs can share one resistor (R3).

10-LED Running Lights Parts List

BAT1
9V
C1
4.7 µF
D1-D10
Red
R1-R2
10 kΩ
R3
470 Ω
RV1
100 kΩ
U1
555
U2
CD4017

How to Build the 10-LED Running Lights

You can build this circuit on a small breadboard, like the one in the Starter Kit. To make the drawing easier to follow, we used a big breadboard here.

Start by placing the two chips across the gap in the middle, and build from there.

Make it your own

Every circuit here is a live project in Circuit Canvas, not just a picture. Copy this one and change a value, swap a part or move it to a stripboard: the schematic and the breadboard layout are linked, so a part added to one appears in the other.

Or start from a blank canvas and draw your own circuit, with thousands of ready-made parts.